Hey all,
I got a 1994 Cherokee 4.0 and for the life of me cannot find the OBD connector. I found a 6pin (maybe 8pin) connector attached near the center console on the drivers side. It's not an OBD II. Does anyone know if Jeep started using the OBD II in 94 like most of the other manufacturers? I know it became standard in 96.
Any other way to get codes other than via OBD?
Thanks, Brian
Brian V did pass the time by typing:
Try looking by the ECU. passenger side, on the firewall in the engine bay. for some years they didn't extend the connector back into the cab.
What's an "ODB"?
On Doard Biagnostic.
LLO!
Does anyone know what this connector *is* for? I have it on my '93. As far as fault codes, the Chrysler ignition key / check engine light method works on mine.
replying to Brian V, Dandre L Anderson wrote: Yea if you put key in the ignition and turn it too the on position then back off three times fast the fourth time leave it in the on position and there you go codes will start to flash pretty quick so be ready. Good Luck!
replying to Joe, Dandre L Anderson wrote: On board diao
Have something to add? Share your thoughts — no account required.
Ask the community — no account required