Have you not re-fitted your door trims yet?
When you do, you may find that you dont have the plastic surrounds for the pull handles (since you gave me 4), and you have an extra lock pluger surround since i only have one!. If you need them then let me know!
pop rivet something with a little drill size hole in over it, sorted!!
On or around Thu, 28 Sep 2006 21:57:35 +0100, Tom Woods enlightened us thusly:
I trust it's not got a cat? removing the cat front pipe and substituting a standard one made a big difference on our TDi disco.
Does anyone know of any exhaust 'part' suppliers?
I need to get hold of a bit of pipe, about 6 inch long, with a flange that will take an olive on one end, and straight on the other.....
Unless someone has one on their lounge floor?
jetex -
Will have a butchers later.
Tom - I actually fitted the door cards last weekend and searched everywhere for the door handle inner bits!
Did i give you the 2 screws aswell?
What are the chances of poping them in the post to me?
you have mail at that email addres. I dont think i got the screws off you but can find you some that will do the job.
yes
no idea - seems the side panels are the same - this 110 already has the sliding windows
no 'frame' works required?
my series hardtop doesnt have anything more complicated than just windows stuck into cut holes using the rubber window seal. The 101 side windows are the same too. They were even done as a DIY job by a previous owner on the 2A cos they arnt quite straight..
On or around Sat, 30 Sep 2006 11:24:22 +0100, Tom Woods enlightened us thusly:
Did I mention that I fitted a window in the near side of Edward II? Came from the partition of a defunct sherpa van, and it's flat, roughly 12"x10" or maybe a bit more, and with rounded corners. Looks like it was made for it, and improves the safety by an amazing amount when pulling out of junctions.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required