... on the Ambulance body.
First, insert the inside roof panel in cab. Then build the entire truck around it...
Interesting 101 design flaw...
Jul 02, 2006
2 Replies
I just replaced my cab roof panels today too! Its loverly working in the heat round all that fibreglass dust!
There is a screw holding the panel in that is inside the side air box!... I very briefly considered removing the ait box but smashing it won over.
I have since fitted 2 new sheets (well one fitted one leaning up ready cut to fit) in the cab and they both slide in fairly easily (once i'd chiselled the remains of that screw out!).
Tom Woods uttered summat worrerz funny about:
Yeahs Bitch in'it.
They could, highly unlikely, but could have fitted the front pannel in but sliding it between the roof and the bulhead frame rearwards in to the back, I've not found anything to prevent (after getting over the screws Tow found) this other than of course the roof pannel in the back and the wires that used to hang down through same.
101 roof , Smashing stuff..... And I thought I was itchy after doing 4 hours on the drive trying to fit new shocker bushes then giving up and grinding the old nuts off. Nowt quite like angle grinder rash on a sticky summers day ;-)Lee D
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required