Hi all,
Daughter just asked me to look at her van as the EML came on last night. I plugged in my laptop / Forscan and found some fault codes and cleared most, but whilst the EML is now out, one fault still persists (the top one, pre clearing them all but left the cleared ones in in case there is some correlation etc):
===PCM DTC P0380-68=== Code: P0380 - Glowplug control circuit
Additional Fault Symptom: - Invalid Signal
Status: - DTC Present at Time of Request - Malfunction Indicator Lamp is Off for this DTC
Module: Powertrain Control Module
Diagnostic Trouble Code details
Glow Plug Circuit
Short circuit
Open circuit.
This DTC may be caused by :
Possible causes are:
Relay control circuit
Glow plug relay
Malfunctioning EDCM
===END PCM DTC P0380-68===
===PCM DTC P0490-E1=== Code: P0490 - Exhaust Gas Recirculation Control Circuit High
Additional Fault Symptom: - Signal is Above Maximum Threshold
Status: - DTC Present at Time of Request - Malfunction Indicator Lamp is On for this DTC
Module: Powertrain Control Module
Diagnostic Trouble Code details
Exhaust Gas Recirculation Control Circuit High
This DTC is set when the following condition occurs.
The EGRV position sensor value is consistently higher than the desired set value.
This DTC may be caused by :
EGR valve short circuit to battery positive.
Exhaust Gas Recirculation Valve
For further diagnostic information refer to the appropriate section of eTIS.
===END PCM DTC P0490-E1===
===ABS DTC None=== Successful DTC reading, no error codes found
Module: Antilock braking system
===END ABS DTC None===
===IC DTC P0000-66=== Code: P0000 - Unrecognized fault code
Additional Fault Symptom: - Signal is Below Minimum Threshold
Status: - DTC Present at Time of Request - Malfunction Indicator Lamp is Off for this DTC
Module: Instrument Cluster
Diagnostic Trouble Code details
While using DLM, check for the following possible faults:
Check for an intermittent electrical fault.
Lightly wiggle on the component and connector while monitoring signals. Take care not to bend or twist any connector as this will cause damage.
Continue to monitor signals and look for sudden changes in values.
Starting at the component, wiggle and pull each component wire.
Wiggle and pull small isolated sections of the wiring harness.
Inspect connectors for signs of damage, water ingress, corrosion, etc.
===END IC DTC P0000-66===
===IC DTC C1210-0A=== Code: C1210 - Right Front Outlet Valve Coil Circuit Failure
Additional Fault Symptom: - Signal is Below Minimum Threshold
Module: Instrument Cluster
Diagnostic Trouble Code details
Right Front Outlet Valve Coil Circuit Failure
===END IC DTC C1210-0A===
===CSM DTC None=== Successful DTC reading, no error codes found
Module: Security module
===END CSM DTC None===
===ECS DTC None=== Successful DTC reading, no error codes found
Module: Electronic Crash Sensor
===END ECS DTC None===
Any thoughts please guys?
Cheers, T i m