Hi folks,
Just had my little Pug 106 valeted, went to start the car and the red light on the immobiliser pad was on but not flashing. Turned ignition key once so battery light came on and red light went out. (Inputting code didn't make green light come on). Turned ignition key off and red light came back on.
Removed immobiliser pad to find two wires loose on the connector plug. Put them back in but now no lights show on the pad. Have checked the fuses behind the glovebox and all okay.
Is there an inline fuse that could have gone? Where does the connector plug route through and fit to on the other end?
Any ideas. TIA
krystnors