Hard starting

I'm a youngin, just started driving and just recently got into cars so if anyone can help me out it would be greatly appreciated

I have a 98 V6 3.8L 120kmi- basically everything is stock(hard enough to pay for the car :-P) but anyways since I've been driving it, I've noticed it takes a few seconds for the engine to turn over. The alternator/starter/battery are fine (free test down the street from my worK) and I just had it into the mechanic for an oil change and to check the brakes. I told them about the starting problem and they told me there was none. This is definitely not natural though, it takes anywhere from 3-4+ seconds to start up no matter what the temperature is, BUT it does seem to start a little faster if the car was recently running. Any ideas?

Reply to
adam
Loading thread data ...

"adam" wrote in news:1127012291.885537.251530 @g43g2000cwa.googlegroups.com:

You dont say otherwise so I will assume the car runs normally in all other aspects. If it DOESNT, say so now. Also assume it has always done this.

Each time you start it cold, try ONE of the following, in order:

  1. switch key on and off twice.. in case your system loses pressure

  1. pump gas pedal 2 or three times while cranking.. sends more gas

  2. hold pedal to floor while cranking... sends less gas

PS - the term "turn over" is misleading, some interpret it a turning while cranking, others as cyls firing while cranking

So "Crank" and "Fire" are better terms

Reply to
Backyard Mechanic

thanx for the warm reply..man i love the internet...i will def try them first thing in the morning...so cranking is before the engine actually "starts" and firing is when the engine starts after cranking?

if anything of these things help do thye mean anythign bad for my car (especially your number 1 suggestion about pressure)

Reply to
adam

Adam, Try some fuel injector cleaner and think about replacing the fuel filter...sounds like low pressure after sitting overnight.

bradtx

Reply to
bradtx

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.