Replacing Z32 starter

On Fri, 22 Aug 2003 16:00:32 -0400, "Thomas Steves" snipped-for-privacy@vt.edu wrote: It's been a while since I changed the starter on my '90 300ZX. I don't remember it being that difficult. I do remember the replacement starter was a little chintzy with the battery connection cable. It was a close fit in that it almost didn't reach the connection. I had a tough time as I had just finished working out a couple of hours earlier and I my arms were getting holding the starter in place while trying to get the bolts started. Make sure to jack the car up pretty high. It will make it a lot easier.

Chilton's didn't make manuals for the Z32.

Dustin

I got lucky guys. After further investigation I figured out that it was actually just the battery that was the problem with my 1990 300ZX not starting. So, Sunday afternoon I drove my other car into town and purchased a new Interstate battery for the Z-car. After thoroughly cleaning the terminals with some CRC battery cleaner and a wire brush, I installed the new battery and the Z-car fired right up. Looks like I escaped a substantial-sized replacement part bill for the time being. I believe a Z32 starter is over $200 U.S.D.

Thanks for the advice on the starter replacement anyway guys! I appreciate the feedback--because I'm sure I'll be needing one in the not too distant future.

Best regards,

S.T.