Matrix for 205 52 reg

Where is the cheapest place in the UK to buy the above. Ta

try camberley autos. or g,f,s. euro parts.you must have a motor factors near you that can help?

Looks like I am going to have to change the heater. Any advise on how its done.

yes glove box out and its all done from the pass side foot well. and it is a sod of a job to do. when i did one we had to remove the steering wheel so we could lift the dash up a little bit. so take your time .

Chris tell me more. I take the glove compartment out and go from there. Do I only need the heater matrix as they call it

On a 405 a couple of years ago it was about £50 from Peugeot. Are you sure it is the matrix and not just o-rings? If a 205 is like a 405 the clamp from the matrix to the feed pipes was only one screw. If a 205 is like a 405 (I don't know) you can clamp the rubber hoses the engine side of the bulkhead to save draining the whole system. Cheers

brenda wrote:

At the start of the pipes which go into the bulkhead into the matrix.

Are you looseing a lot of water from it ?? you might be able to plug it with some rad weld.untill the warmer weather gets here.