Arduino Control Box Grows Out of a Hot End Project

Nov 20, 2026 Last reply: 1 hour ago 4 Replies
Jump to replies (4)

Most people tinkering with Arduino and car electrics start with one small job and stop there. Bad Obsession Motorsport began with what was meant to be a simple heater project for a 3D printer hot end, and it turned into a complete custom lighting and gauge control system through plain mission creep. That is exactly how the best shed builds seem to happen.



The heart of it is a custom electronic control box attached to the printer, built around an Elegoo Uno R3. The internal hardware was laid out on the workbench before assembly: an adjustable buck converter, a B20K rotary potentiometer, a dual-MOSFET PWM trigger module, a cylindrical heating cartridge with braided red leads, and an NTC thermistor sensor. The code is written in the Arduino IDE under the name BOM_Printerator.



The standout piece for me is the rectangular colour TFT display in its black plastic enclosure, fitted with switches and LEDs. It reports live nozzle and bed temperatures in degrees Celsius, with the words BOM'S PRINTENATOR across the face. The soldering on the box looks careful and properly handmade too, which suits a project of this sort.



The one unfinished item sits on the gauge face itself: there is a petrol pump symbol but no small arrow to tell you which side the filler is on. Tiny detail, yet on a project this tidy it seems worth closing out.



Project by Bad Obsession Motorsport. Watch it on their YouTube channel:

formatting link


Going with a bog-standard B20K rotary pot for the manual control strikes me as a clever move. The trade-off is that a plain pot has no detents, so finding a saved setting again means watching the display rather than feeling for a position.

Does anyone know how the NTC thermistor is hooked into the Uno? Is it read straight off a pin, or does it go through the dual-MOSFET PWM trigger module first?

The maker has not said how the thermistor is wired in. What is known is that the box includes an NTC thermistor sensor alongside the dual-MOSFET PWM trigger module and the buck converter, and the TFT reports live nozzle and bed temperatures in degrees Celsius, but the exact wiring path has not been shown.

A quick improvement: print that little filler arrow beside the petrol pump symbol on the gauge face, styled to match the rest of the dial. It costs next to nothing, and nobody borrowing the car has to stand at the pumps guessing which side the filler is on.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required