Fading Dome Light

97SL1 One bit of class I miss in my saturn is a dome light which fades off when I close the door. Is there a simple way to implement this?

I went through the calculations of a basic RC circuit, and to add a capacitor to the system would require a charging current which would pop a fuse when I open the door... long story short: *theoretically* a basic parallel capacitor won't work... :(

The second idea I have is using an small RC model curcuit to set the discharge time, and use a voltage buffer circuit ot feed the bulb... however I believe there should be an easier way.

Any ideas????? (preferrably pre-built :) )

Thanks!

Reply to
Nathan
Loading thread data ...

Try a resistor in series with the capacitor to slow the in-rush.

Reply to
Skid

If you have a LARGE capacitor, two diodes and a resistor, this approach will work. You charge the capacitor through a resistor and a diode. The resistor can be sized so that it will limit the current into the capacitor so that the fuse doesn't blow. You also supply the current to the bulb through another diode, and have a diode from the capacitor to the bulb.

However, there is an implementation problem with this approach - it requires a capacitor on the order of a Farad. Those are large (about a tall-boy beer can) and relatively expensive.

A simple two transistor, one capacitor and a resistor or two will do the trick. It's a bit beyond the scope of a newsgroup post to describe though...

Reply to
Kirk Kohnen

Will a 2 transistor amp handle the power requirements? My practical experience with transistors has been limited...

Also, does anyone know of a module (from a junkyard or so) that I could just 'plug and play' type thing? I think most of these things are pretty integrated, however just curious :)

Thanks again for the input!

(And yes, a 1F cap is out of the question!!! :) )

Reply to
Nathan

Actually a 1F cap is about $2 on digikey.com if you can deal with a 2V or 5V rating. The supercaps are getting cheaper every day.

Reply to
Igor Orlovich
1) You'd need about a 15 Volt rating if you wanted to use the cap to directly feed the bulb. 2) The small super-caps have a very high internal resistance. They're more oriented towards supplying the low currents over a long period of time that are used for applications as memory backup. The capacitors that have large values (on the order of a Farad), sufficient voltage (on the order of 15 Volts) and sufficiently small internal resistance are still about the size of a tall-boy and cost about $100.

3) PS - Yes, a two transistor circuit would be able to handle the power. And, since the output transistor would only be dissipating while the light is being dimmed (not when it's full on or full off) you probably wouldn't need a heat sink. Of course, if you sit there turning your light on and off repeatedly, you could overheat the transistor this way...

Reply to
Kirk Kohnen

I found solutions! :)

I found a homebrew solution at:

formatting link
I also found a prefab solution at:
formatting link

Thanks for your help! Cheers.

Reply to
Nathan

The one with the OP-AMP is a little over-engineered - a simple two transistor circuit will do the trick.

But, 741s are cheap and commonly available, so I see no reason that way shouldn't work just fine.

*theoretically*
Reply to
Kirk Kohnen

That's the one that would pop the fuse, due to the large cap needed.

Simplest solution is an R-C circuit driving an emitter-follower, possibly in two stages.

Reply to
Dan Hicks

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.