I have no rear brake lights at all left/right/Third. All other rear bulbs work fine, signal, hazard, tail but when i press the brake pedal, i get nothing. Now the enging was replaced a few days ago, is there any ground for the brake lights to the enging block that they may have forgotten ?
Thanks
Is there an electrical BRAKE SWITCH under the BRAKE PEDAL that is actuated when you apply pressure to the BRAKE PEDAL?
Is this switch, if it exists, being actuated? Is it even hooked up electrically?
Have something to add? Share your thoughts — no account required.
Ask the community — no account required