Automotive Technologies

15186 Threads Posts
to

how to tighten tie rod nut

I installed a rear camber kit on my accord and when I try to tighten the tie rod nut, the tie rod stud rotates along wi...
5 comments posted 22yrs
posted by joecruz2
5 comments posted 22yrs posted by joecruz2

ID help needed on VDO Speedometer...reward

Greetings all, I have located an old speedometer, still in the box and need help IDing it. I am helping a friend clean...
3 comments posted 22yrs
posted by Boulderflush
3 comments posted 22yrs posted by Boulderflush

high rpm

I post again a problem I have with my 91 old cutllas supreme 3.4. While the car is cold and the outside temperature is...
1 comments posted 22yrs
posted by sknipas2000
1 comments posted 22yrs posted by sknipas2000

Strange whining in 1995 Eagle Vision

I have a 1995 Eagle Vision ESi with about 131K miles on it. In the past few months it has starting to make a strange id...
0 comments posted 22yrs
posted by jetmanba
0 comments posted 22yrs posted by jetmanba

Auto trans slippage

I have a 1 yr old Mitsubishi Space Star (Dutch designed and built) with 6,500 km on the clock. It has had a problem wit...
4 comments posted 22yrs
posted by linw
4 comments posted 22yrs posted by linw

MAZDA 929 Timing Belt problems

89 929A SOHC Motor. I've started to work on the timing belt on the car. After I took off the covers I find a LOT of wha...
4 comments posted 22yrs
posted by R.nospamMagowan
4 comments posted 22yrs posted by R.nospamMagowan

94 Astro AWD Spontaneously Breaks Torsion Bar?

I have a 1994 Astro AWD with the front suspension similar (if not identical) to the 4WD Blazers, Sonomas, Jimmys and S-...
0 comments posted 22yrs
posted by jrmitch
0 comments posted 22yrs posted by jrmitch

Ford Contour SVT Throttle Sticking

2000 Contour SVT [I'm not great with automotive terms, so I may call something by the wrong name. Please bear with me.]...
3 comments posted 22yrs
posted by cwillyATE
3 comments posted 22yrs posted by cwillyATE

How Much to Replace a GM 3.4 DOHC Timing Belt?

Hello All What is the cost to have the timing belt replaced on a GM 3.4 DOHC engine? If you've had this job performed o...
11 comments posted 22yrs
posted by clemke
11 comments posted 22yrs posted by clemke

passat help

This car came in with valve bent,found the timing belt slipped.Has anyone seen this? Joseph Lee christian autotech netwo...
0 comments posted 22yrs
posted by ilovechurch
0 comments posted 22yrs posted by ilovechurch

HELP! Dead Honda Civic!

My 1994 Honda Civic EX coupe died tonight. It was running fine for about half an hour...then i turned it off for about...
4 comments posted 22yrs
posted by ress199
4 comments posted 22yrs posted by ress199