Automotive Technologies

  1. Home
  2. Automotive Technologies
15187 Threads Posts
to

Worth reading in Automotive Technologies

FS: 2.3 Ford engines in bay Area, CA

I have one 2.3 mustang engine and one 2.3 pinto engine I also have a mustnag computer (92 I think) The engines are compl...
0 comments posted 23yrs
posted by pwcfrazier
0 comments posted 23yrs posted by pwcfrazier

Back-Flush and engine petcock...

Thank you in advance for any help. I am looking to back-flush my son's 1996 Chevy Blazer 4.3 V6 (w). I have Chilton's b...
6 comments posted 23yrs
posted by hakone
6 comments posted 23yrs posted by hakone

1996 Neon stalls only in Right hand Turns?

Hi a buddy gave me his 1996 Plymouth Neon 2.0 SOHC to tune up and address a problem when turning to the right, the car...
0 comments posted 23yrs
posted by Bushleague
0 comments posted 23yrs posted by Bushleague

Re: Brakes heating up

Don't cool the rotors with water, you could warp them. But anyway, this could be a problem with the brake hose collapsi...
1 comments posted 23yrs
posted by djsljsrn
1 comments posted 23yrs posted by djsljsrn

buick skylark codes

My aunts car has started to flash the check engine light. It is a 1982 Buick Skylark. Is there a way to get the codes ou...
0 comments posted 23yrs
posted by adr5
0 comments posted 23yrs posted by adr5

Slight hesitation

What can be the cause of a flat spot in accelerating at about 3k rpm? When I gas it goes hesitates and then takes the ga...
6 comments posted 23yrs
posted by Foosdawg-Hard
6 comments posted 23yrs posted by Foosdawg-Hard

Camber Caster Gauge

Hi all, Just purchased a Camber Caster Gauge 2501/2 made by Replex Pty Ltd. Melbourne Australia. There where no instruc...
3 comments posted 23yrs
posted by nospam
3 comments posted 23yrs posted by nospam

Escort with idle problem + high feul consumption

I have an -88 Escort 1.6i which in idle is running up and down in rpm with a constant frequency (a couple of seconds be...
4 comments posted 23yrs
posted by mmati99
4 comments posted 23yrs posted by mmati99

Smoking engine on 1963 Mercury Comet

I have juste bought a 1963 Comet and the motor recently started to smoke from a pipe on the front base of the motor when...
8 comments posted 23yrs
posted by dlachance
8 comments posted 23yrs posted by dlachance

replacing outer tie rod ends - aerostar

Hi I've never replaced my tie rod ends and plan to do so. I've planed and read that I should do the following. Can some...
9 comments posted 23yrs
posted by ortho
9 comments posted 23yrs posted by ortho

Carb base leaking

I spead carb cleaner to the base on my 87 Accord and the engine rev up,is anything I can just patch base of the carb to...
2 comments posted 23yrs
posted by a123321345
2 comments posted 23yrs posted by a123321345

OBDII scans?

Was wondering, has anyone had experience with OBDII PC interface and scan software such as available at www.obddiagnost...
0 comments posted 23yrs
posted by tc.meyer
0 comments posted 23yrs posted by tc.meyer

A/C vacuum only goes to -20psi, but holds?

My A/C system in a 94 Crown Vic was completely empty of refrigerant. I replaced the accumulator, o-tube, and a bunch of...
2 comments posted 23yrs
posted by JFB_821
2 comments posted 23yrs posted by JFB_821

2003 Jeep Cheroke Engine Code 3

Hi All: I recently posted an issue about my brothers leased 2003 Jeep Cheroke. Apparently this vehicle has left him str...
0 comments posted 23yrs
posted by finitetheelement.guy
0 comments posted 23yrs posted by finitetheelement.guy