2006 Camry JBL radio harness?

Try crutchfield.com.

Try Wal*Mart. The connector is specific to the car, not the radio. They have them for $7.

The only problem here is presented by the amp. I am not sure if the head unit sends out a low-level signal or if there is an attenuator built into the amp. I know on Chryslers there is an attenuator in the amp, so you can plug in any moderate-powered head unit, but Toyota may work differently.

If you plan on bypassing the amp, there are companies that make a harness that attach the incoming connector to the outgoing connector, but the only place I an aware to buy these is online. If you're handy with an ohm meter you can figure this out yourself, or look online for a diagram...

Good Luck!

Take a look at Scosche's web site. I believe I saw something there for JBL car audio.

Well, it turns out that I didn't need a harness that fit the plug at the amp. Also, I didn't need a harness that fit either radio plug.

Thanks to an installer at my local Circuit City, I was able to get this done.

The standard Toyota harness that you can get anywhere will work - the trick is to find the place to plug them in. The cables are tied down under the radio, where you can't see them. Digging them up reveals the standard connectors, unplug them and nothing goes to the Amp anymore, so it can be removed. I didn't even need to expose the amp - you can do the whole job right in the dash area thanks to those connectors being there.

Thanks for the replies

Netsirk wrote:

Thanks for the info! As you can see, my 'guess' was wrong. Bet your 'gums' I'll file this one away for future reference!