Is there a trick to get the crankshaft pulley nut off when it is not still in the truck and stripped down almost to the short block?
Crankshaft Pulley Tricks
May 23, 2004
2 Replies
Yeah a good strong professional air power wrench.
Or use a board to wedge the crank against the block, a breaker bar, and a length of pipe over the breaker bar. Any board splinters will go away when you clean the block. (apparently you're disassembling it)
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required