Hi ramva! I just finished cleaning up the engine (cleaning inside out, changing all gaskets, fixing exhaust studs) and it definetely feels crisper. I checked the compression (twice), changed the spark plugs and wires, adjusted the valves and adjusted the carb on idle. there is something weird going on with the dizzy though. It is a toyota electronic distributor installed by a PO. It's suposed to be a centrifugal-vacuum type, but the vacuum port is broken and there's no hose, so I statically timed it to 7.5 BTDC and fired up the engine. All good so far. Connected the timing light and checked again the RPM's, 900, ok. Then pointed it to the marks on the pulley and when pressing the throtle, the marks move to the right! aren't they suposed to move LEFT? moved the dizzy a little and noticed the RPMs go up when advancing, maximum RPM's close to 30 BTDC!!! Press the throtle and it goes down to 8-10 BTDC!!! Isn't this proof that it is retarding the ignition? How should I set this?
TIA, Karls