> Want to install a dual carb setup (Kadron) to replace my old carbs
> (Webers). Need to remove and replace intake manifolds. Looking in my
> engine, I cannot even see where the manifolds are connected to the
> engine. Is it possible to change out the old for the new set by first
> removing all the engine tin? How difficult is it to reach the two nuts
> holding the manifold on if I remove the tin?? Definitely want to avoid
> dropping the engine to do this. TIA for advice, opinions.
> --
> Emily Steed
> Please post your response to NG, thanks.
You CAN'T even drop the engine without first removing the carbs and intake manifolds. So yes, it is possible.. lol
Jan