850 brake lights out!

i don't have brake lights on my 96 sedan...checked fuse panel under hood....appears to be one 10amp fuse controlled which is good. checked bulb in tailight assembly and they appear good...assume it is a defective brake light switch near pedal area....is the switch adjustable? is this most likely the issue? is there a trick to getting to the switch? are there other areas to check other than those already checked? not as familiar with the little "got chas!" on this vehicle as i am on the 911 turbo! thanks in advance for suggestions/observations

regards

Reply to
euro930
Loading thread data ...

Check to see if you are getting power to the bulbs when depressing pedal. If not, check power into and out of the switch. A burned out switch is not uncommon. To replace the switch, pull the switch body back towards the steering wheel. You will hear a ratcheting noise. reach around the front side of the switch and squeeze the tabs. (It will be very useful if you have a new switch to look at, before removing the old one) Snap the new switch into place, being careful to notice it is keyed to go in a certain way. Connect the plug. Depress the brake pedal and push the switch all the way in until it bottoms out. Release the break pedal to set the switch to it's correct position.

Reply to
Ron

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.