Error codes

Jan-Erik wrote in news:6Mvee.9232$SL4.209889 @news4.e.nsc.no:

I go here for codes, but not sure they are the same for a 240.

A2 232 Long-term fuel trim, at idle, at upper or lower limits

A6 144 Ignition control module load signal missing

Where should I start to look or see whats wrong. I havent loads of cash to deliver the car to the repairshop.

For 2-3-2, start with vacuum leaks and fuel pressure.

For 1-4-4, the ignition module gets load information from the fuel computer to set the advance curve. There's not much that can go wrong to cause this code that doesn't involve the few wires that connect the 2 control units. I'd just clear this one and see if it comes back.

I have checked for vacuum leaks but all hoses and tubes are OK, How high should the fuel pressure be?

I have tried to reset but it won't reset. Is there another way to reset?

Got it! changed the fuelfilter and unplugged the battery for a while When I changed the fuelfilter. And now it's raporting 1-1-1!!!!!!

Resetting procedure only works if all codes have been read. You should make sure of this by comtinue reading procedure until you see the first code once again. Of course if you get the same code ( here 2-3-2) rigth away this is the only code stored. Unplugging the battery will delete all codes, but you migth not have read them all.

Regards

Per Hauge

"Jan-Erik" skrev i en meddelelse news:naOee.8928$ snipped-for-privacy@news2.e.nsc.no...

It jest said 2-3-2 and 1-4-4 and repeated it when I tryed it again then there is no more stored codes I'we been told

Per Hauge wrote: