Time to get started on bending up my brake lines. The new ProRock 60 comes without brake lines, so today I went to Orme Brothers in Northridge, CA and had them swage up a pair of stainless braid extensions while I waited. I got 3/16" brake line in two 10' STRAIGHT lengths. These guys are tops.
I wish Dynatrac had installed a post to affix the ...I forget the name...the whattyacallit ( the block with the hole in it that tees the flex line to the hard-plumbed lines.) I guess I'll use the driver's side axle plug with an adapted capped pipe to hold it.
I researched Google for discussion on the upgrading of the master cylinder, to accomodate the extra capacity of 11" rear drums and front disc brakes.
Does anyone have a good recommendation for a suitable, easy to find replacement MC that will do the trick? I doubt I'll find a 79 Mercury MC with much luck, which was the unit spoken about previously.