Chevrolet Trucks

1998 GMC 2500 Sierra - Tow in D or 3

Hi all - I typically tow my 7Klb travel trailer with my 4.6 V8, 1999 F-150 Lariat with 6' bed and have no problems. We...

4 comments posted 12yrs

posted by noreply

4 comments posted 12yrs posted by noreply

4.3l gm motor- blue smoke/intake gasket/head gasket

I recently bought a 95 GMC Jimmy 4.3Lwith 230,00 on it. Idle was rough so I replaced EGR, PCV, and IAC. Still runs roug...

5 comments posted 12yrs

posted by Stagger Lee

5 comments posted 12yrs posted by Stagger Lee

Engine failure Yukon XL 2008 1500

I was told that my GMC Yukon 2008 1500 XL could have engine failure because of the 8 cylinder - 4cylinder Econ option. I...

1 comments posted 12yrs

posted by Mark

1 comments posted 12yrs posted by Mark

Flawed design in Chevy & GMC frames - Recall Needed

Okay, I'm not a troll. I have a 2005 Silverado straight cab, full bed 4x4 with 75,000 miles on it. The exterior looks g...

5 comments posted 12yrs

posted by nowhere

5 comments posted 12yrs posted by nowhere

6.5 Diesel and seafoam

Hi I took the air temp sensor out and put seafoam in the intake the engine sounded like it was coming apart . It knocke...

0 comments posted 12yrs

posted by the r

0 comments posted 12yrs posted by the r

03 S10

Hey everyone I am new to this forum and I need some help I have been search ing around high and low for a new third doo...

2 comments posted 12yrs

posted by eric.perry007

2 comments posted 12yrs posted by eric.perry007

04 tahoe driver seat electric seat schematic-seat locked in forward position

my fore and aft seat motor on drivers seat has locked up. Is there a way to take track apart, remove the motor and turn...

1 comments posted 12yrs

posted by yukondoit

1 comments posted 12yrs posted by yukondoit

van door latch

My 1995 van door latch (half way up the side of the door) doesn't want to stay lubricated. I've tried WD, motor oil, AT...

8 comments posted 12yrs

posted by cayoung61

8 comments posted 12yrs posted by cayoung61

'98 Silverado 1500 Fuel Gauge

Fuel guage has recently become eratic. Anyone have any experience wether it'll be the gauge, sender or ground? Is it po...

7 comments posted 12yrs

posted by BF

7 comments posted 12yrs posted by BF

1988 S10 PU 4.3L Wipers Off

I cannot see how to remove the wipers. Some video shows a lever to release but mine have no visible means of removal. H...

7 comments posted 12yrs

posted by OldGuy

7 comments posted 12yrs posted by OldGuy

1988 S10 PU 4.3L Wipers Out

1988 S10 PU 4.3L Wipers Out I cannot find a wiring diagram. Wipers just totally quit. The diagrams I have found for my...

7 comments posted 12yrs

posted by OldGuy

7 comments posted 12yrs posted by OldGuy

S10 blazer frount Clip. 95 bvas 98

I have a 95 S10 blazer (granddaughter + ice + tree) that needs a front clip I have available a 98 blazer frount clip. A...

3 comments posted 12yrs

posted by me

3 comments posted 12yrs posted by me

anyone know where I can mount a magnetic block heater on a 4.3 V6, "02-S10 4x4 ?

Automatic tranny. Would also like info/diagnose on my exhaust system. it's the same "02 S10, 4.3L, 4x4, w/ california-r...

1 comments posted 12yrs

posted by John f Kn.

1 comments posted 12yrs posted by John f Kn.

98 Blazer starting problems

Some days, my Blazer gives me trouble starting. usually only first thing in the morning. Mechanic says it sounds like i...

112 comments posted 12yrs

posted by cayoung61

112 comments posted 12yrs posted by cayoung61

tire diameters

Can someone please tell me where to find the diameters of P185/70R14 and P195/70R14? If you know the difference in diame...

3 comments posted 12yrs

posted by footboarder

3 comments posted 12yrs posted by footboarder