I found the RAB connector and grounded it and it gave me one fast flash and one long code that = code #2. In the manual it says to unconnect the 2 ends of the RAB connector and ground out the orange/black stripe to get antilock light to flash...only problem is my RAB connector was not connected to anything and was just sitting there unplugged. Ive searched and cant find any other plug that would plug into the orange/black plug end. Should this connector be plugged to something..maybe this is why light is on??? Thanks in advance for the help!! :)Nel
1987 f150 abs code #2??
Nov 25, 2006
6 Replies
Any ideas??
On Mon, 27 Nov 2006 23:08:10 -0500, :) :))) rearranged some electrons to form:
Fault code 2 = Open isolation valve circuit or defective ABS module
Thanks David:) Any idea where any of these 2 are? Thanks again:)Nel
On Tue, 28 Nov 2006 22:49:03 -0500, :) :))) rearranged some electrons to form:
I hope you're kidding.
Isolation valve is near the master cylinder, ABS module is in the passenger compartment somewhere (varies by vehicle).
Hello David, Thanks for help again!! I will try to find these. I wasnt kidding:)...dont know much about cars...but am learning...trying to anyways:) Thanks again! :)Nel
On Thu, 30 Nov 2006 01:57:30 -0500, :) :))) rearranged some electrons to form:
If you don't know much about cars, you should not be messing around with your brakes.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required