Ford Trucks

FS: Yakima Roof Rack

For Sale: Yakima Roof Rack: Fit a 1993 Aerostar (4) Rail Rider Towers fit onto the factory roof rack rails (2) 58" Cros...

2 comments posted 23yrs

posted by SkiDog

2 comments posted 23yrs posted by SkiDog

Re: My new sticker

I saw a POS Hyundai with a sticker of a kid pissing on a ford emblem the other day, too each his own - I guess....... I...

0 comments posted 23yrs

posted by dd

0 comments posted 23yrs posted by dd

Re: Replacing headliner How to do

We did it on our '80 bronco. Just used 3M 8080 spray adhesive. No special problems.

0 comments posted 23yrs

posted by railphotonut

0 comments posted 23yrs posted by railphotonut

91 Ranger - Fuel Pump Connector Volt Reading

I recently replaced my intank fuel pump. The pump runs fine when bench tested but I get nothing when installed on truck...

0 comments posted 23yrs

posted by rebelson

0 comments posted 23yrs posted by rebelson

Re: 2000 ranger pinging (= valve rattle?)

Is this the same problem as valve rattle under load; i.e., going up a hill? I have this prob, and have been spending go...

0 comments posted 23yrs

posted by anfo

0 comments posted 23yrs posted by anfo

Cam Position Sensor 1999 F-150 5.4L

Anyone tell me the location and settings for this sensor. The Check EngineLight came on and AutoZone checked it and sol...

1 comments posted 23yrs

posted by bsaems

1 comments posted 23yrs posted by bsaems

Econoline 150 - shock suggestions

I have a 1998 4.6L V8 cargo van with 60K miles on it and would like to get new shocks all around. It's usually lightly...

0 comments posted 23yrs

posted by vze3n4p8

0 comments posted 23yrs posted by vze3n4p8

Re: WTB Keyless entry remote

There are a million (well not a million but scads) of them for sale on ebay. Where I got mine. > After looking for my l...

0 comments posted 23yrs

posted by bomar76

0 comments posted 23yrs posted by bomar76

Re: ford F-350

I think the problem is that 265 tires will not have the clearance between the tires. They are to big. Suggest that you...

6 comments posted 23yrs

posted by Mel

6 comments posted 23yrs posted by Mel

Re: rusted on bumper bolts - need to get loose

I suggest you use some penetrating oil rather than the 3 in 1. You can get it in a aerosol can at any parts store. Just...

3 comments posted 23yrs

posted by jor

3 comments posted 23yrs posted by jor

MAF sensor location?

Hi all & thanks for so much good information. I have been following the posts regarding cleaning the MAF sensor to stop...

3 comments posted 23yrs

posted by noway

3 comments posted 23yrs posted by noway

Attn Joe G/ Re; Ranger A/C

HEy, thanks a lot Joe. Iv'e had a hard time finding any info on this - even in the CHilton manual. I was hoping you cou...

1 comments posted 23yrs

posted by noway

1 comments posted 23yrs posted by noway

Propotioning valve

Hey folks! I'm trying to locate a Proportioning Valve for a '73-'75 F-250 with drum brakes - part number C8TZ-2B257-C -...

0 comments posted 23yrs

posted by gordh

0 comments posted 23yrs posted by gordh

Re: hot starter

I have a 91 bronco, when the motor is really hot, it turns over really slow, like it is gonna guy. Is that the same thin...

2 comments posted 23yrs

posted by pfunk20000

2 comments posted 23yrs posted by pfunk20000

Trailer Wiring on Expedition problems

I have a 2000 Expedition. I am using the flat 4-Prong plug that was installed from the factory. About 2 years ago, I to...

5 comments posted 23yrs

posted by bsmall69

5 comments posted 23yrs posted by bsmall69