The programming connector is in the trunk. Look near the right lid
hinge, in the wheel well area.
a.. Do the following procedure whenever the Keyless Programming Connector
is grounded, the Keyless Entry Receiver is replaced, the Transmitter is
replaced or a second Transmitter is added.
1.. Jumper the Keyless Programming Connector to ground (all power door
locks will lock and unlock).
2.. Operate Transmitter by pressing a single button once (all power door
locks will again lock and unlock).
3.. To program for a second Portable Transmitter, operate Transmitter 2 by
pressing a single button once. In order for programming to be complete, wait
for the locks to fully cycle.
4.. Disconnect Keyless Programming Connector Jumper after locks have
5.. Verify that the Transmitter(s) operate Door Locks and Trunk Lid