Best Rated threads in Jeep and Willys (new and old)show all threads
Subject | Author | Posted | Replies | |
---|---|---|---|---|
|
86 Cherokee overheating problem
Good evening, I have a 1986 Jeep Cherokee Pioneer with a 2.46L 4-150 engine with an overheating problem. I just purchased it as a basket case and am trying to get it back on the road again. I found...
8
|
19 years ago
|
8 | |
|
98TJ 4.0L with no compression in cylinder 3 - long
This morning on the way to work I lost power while doing about 30mph up a slight hill. Turned into a parking lot to diagnose the problem. Sounded like I lost a cylinder. No abnormal sounds like...
13
|
19 years ago
|
13 | |
|
2000 TJ Blower motor
Hey guys, Just wondering if you know of a good place, preferably in Canada, where I'd be able to get a new Blower Motor for my TJ. Now it isn't working at all, and this is after changing the resistor,...
1
|
19 years ago
|
1 | |
|
A/C questions
Ok...a/c has not worked properly in 3 years but I never have cared...now that someone doesn't want her hair messed up, I am exploring what may be wrong. Heeding the warnings and advice of some who...
2
|
19 years ago
|
2 | |
|
Dana 35c Overhaul questions
The original symptoms were noisy rearend. At least half of the noise went away after I installed new wheel bearings and new axles. The noise that remained was on acceleration and deceleration between...
30
|
19 years ago
|
30 | |
|
Solar Yellow Discontinued?
Does anyone know if solar yellow has been discontinued on the 2005 Wrangler? Thanks. Bill Donovan
5
|
19 years ago
|
5 | |
|
Early Jeep Question for Bill Hughes (or anyone else who knows answer)
Bill, I am completing the rehab of my '46 Bantam BT3C trailer, and need to replace the bearings, races, oil seals and flange gaskets on the axle. It is a full floater which I believe uses parts...
10
|
19 years ago
|
10 | |
|
Tan vs. Spice
Hi All, I'm thinking about swapping my half doors for full doors. The guy I'm swapping with has a '99 TJ, I have a '98. I am already planning on re-painting the outside of the door, but I'm unsure of...
8
|
19 years ago
|
8 | |
|
96 jeep grand cherokee intermittant exhaust smoke when air conditioner on
Maybe some of you have an idea what this is ? My 96 Grand Cherokee has 180K miles on it. Recently (on 2 occasions) while on the highway, I noticed a decent amount of smoke in my rear view mirror. I...
11
|
19 years ago
|
11 | |
|
Grand Cherokee Alarm Problems
Hello, I have a 96 Grand Cherokee Orvis Edition and the alarm will randomly set itself off while parked(mostly at night of course!). I know that the alarma nd the locking system are tied together, but...
3
|
19 years ago
|
3 | |
|
CJ5 in a Uhaul ?
I have my 81 CJ5, and I will be moving across country. I wanted to know if anyone ever tried loading a CJ onto a U-Haul. I have another car that I am planning to tow, and I wont have anyone else to...
11
|
19 years ago
|
11 | |
|
Where to tap off switched 12V in a WJ?
I'm looking for a wire to tap into on my 2004 JGC to get switched 12V for my radar detector. I looked under the drivers side dash but all the wires are loomed together so neatly that I can't get to...
5
|
19 years ago
|
5 | |
|
MSD-6al ignition for an AMC 360?
Hi guys. I'm thinking about putting an MSD-6al into an '82 AMC 360 motor. This ignition has a rev limiter which can be programmed for 3000, 6000, 7000, and 8000. I'm just wondering what the red line...
9
|
19 years ago
|
9 | |
|
Howto Recharge Ac in 97 TJ?
Folks, My AC just isnt as cold as it used to be.. its nothing that happened overnight. I was just in a new TJ the other day and noticed the AC was a lot colder. I would like to recharge the system and...
5
|
19 years ago
|
5 | |
|
what are the outer knuckles on a dana 30 made of?
does anyone know what material the outer knuckles on a dana 30 front (85 cj7) made of? cast iron? forged steel? thanks!
4
|
20 years ago
|
4 | |
|
'77 CJ5 Jeep w/electronic ignition problem
Maybe someone here can help me figure this out. I have a 1977 CJ5 straight-six jeep with electronic ignition and I'm getting no spark from the coil. I'm guessing it's the electronics module, but I'd...
11
|
20 years ago
|
11 | |
|
1987 Jeep Cherokee Pioneer Transmission Problems
For some reason my Jeep transmission fails to engage when I put it into any gear. I have an automatic transmission with 4WD. Sometimes it goes into gear and sometimes it doesn't. Also, the 4WD light...
5
|
20 years ago
|
5 | |
|
removing spindle...dana 30 on an 85 cj7
ok guys-in my quest to rebuild the front axle, i have run across impossible-to-remove spindles. i have a dana 30 front. i've removed everything off of it- hubs, brakes, backing plate, pressed-in...
30
|
20 years ago
|
30 | |
|
Distributor noise?
I have have 1996 Jeep Grand Cherokee 4.0L, and one morning I went out to start it up and it started and ran fine, but it started making a sort of belt squeaking sound. I checked the belts and they are...
24
|
20 years ago
|
24 | |
|
cj3a tire conversion
Hello I am trying to change the 600 x 16 tires on my 49 cj3a. does anyone know a modern p-metric code that would be best to use.
4
|
20 years ago
|
4 |