Grand Cherokee oil level sending unit???

May 07, 2005 9 Replies

Just added a second jeep to the drive, a 1993 grand (ZJ??), anyways the only fault it has is that the oil level sending unit is wonkie, anyone know where I can get info on this thing? wiring diagram? or ??? .



Thankies Snow...


Snow did pass the time by typing:

It's basically a switch, cleaning the connector always works for me. If you need schematics on anything let me know. Some I have scanned.

Yep its oil level sensor, the info centre display says it is... I have physically checked the oil and its full..

Snow...

you have a schematic for the oil level sensor / switch ? figure I'll also check the wires at the same time. you can email them to this addy.

Thanks Doug

Snow...

You still don't know if it is the sensor or the oil level. As I stated before, filling the oil to the full mark on the dip stick is still TOO LOW for reliable oil level sensor operation. This only apples to the early '93's (like mine.) When you get the low oil message on the VIC, it can be either low oil or a sensor problem. It doesn't distinguish between them. The easy way to check is to add

1/2-quart to the engine after it shows full. That's what the factory wants. Apparently, the oil sensors in the '93 are positioned to the ragged edge of failure, and there is nothing you can do except add more oil. This appears to have been corrected in the later 93's.

Here is what the service manual says about the sensor:

"The module will test the oil sensor input immediately after ignition ON. If low oil is detected during the test OR the oil level sensor is bad, the VIC will display this message. The engine on the vehicle outline will also be illuminated. Ignition must be OFF for 1 minute before the oil is checked. If the fault is found, the message will stay on until the ignition turns OFF. Unless the ignition has been off for one minute or longer and the oil fault fixed, the fault will appear again on the next ignition ON."

There are two TSB's regarding this problem. The first one applies only to version 03 of the Vehicle Information Center (VIC). The one I have is No. 08-22-93. If the VIC displays"Oil Sensor Shorted" while in diagnostics mode, the sensor may actually be open and visa versa. The diagnostics mode is entered by depressing and holding the select and set buttons simultaneously, while turning the ignition switch on.

The second TSB, 09-16-92, is the one describing increasing the oil capacity to 5.5 quarts and using a newly calibrated dip stick. This bulletin applies to vehicles built prior to MDH 08-22-XX and equipped with a 5.2L engine and a vehicle information center.

Dick

Thanks Dick, I'll try the diagnostic mode for the vic, by looking at the dipstick it is close to being a 1/2 litre over the full mark, but I'll look again.

Snow...

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required