power windows control assembly

REMOVAL

(1) Disconnect and isolate the battery negative

cable.

(2) Remove the trim panel from the inside of the

front door. (Refer to 23 - BODY/DOOR - FRONT/

TRIM PANEL - REMOVAL).

(3) Disconnect the door wire harness connectors

from the door module connector receptacles.

(4) Remove the three screws that secure the door

module to the front door trim panel (Fig. 8).

(5) Remove the door module from the front door

trim panel.

INSTALLATION

(1) Position the door module onto the front door

trim panel.

(2) Install and tighten the three screws that secure

the door module to the front door trim panel. Tighten

the screws to 2.2 N·m (20 in. lbs.).

(3) Reconnect the door wire harness connectors to

the door module connector receptacles.

(4) Reinstall the trim panel onto the front door

inner panel. (Refer to 23 - BODY/DOOR - FRONT/

TRIM PANEL - INSTALLATION).

(5) Reconnect the battery negative cable.

Thank-you Billy Ray..

It worked great!!

Do I need the whole assembly for the lock-out switch malfunction??

Would a bypass work??

Does anyone know a good deal on a new assembly??

Thank-you again!!

Jim