What's wrong with this picture?

LOL!

Is there anything 'right' on it?

Mike

Cherokee-LTD wrote:

its backwards.

the FWD label is going the wrong way.

-- bob z. p.s.

"people with less brain power than you are doing more difficult things everyday"©

DING DING DING You are correct... I've rolled my eyes at many of these diagrams but that takes the cake.

-Brian

: the FWD label is going the wrong way. : : -- : bob z. : p.s. : : "people with less brain power than you are doing more difficult things : everyday"© : :

i'm a 'design engineer', so i get to make 'purty' drawings like that all the time. mine are usually a little better, though.

bob z. usually hangs out in comp.cad.solidworks, but found rec.autos.makers.jeep+willys since the rubi was acquired.

-- bob z.

bob zee beat you by a minute according to my news reader. You do qualify for the runner up prize, an ice cream cone.. I'll need your shipping address LOL

-Brian

I am looking for a very simple, preferably free program that could make those drawings. I'm looking for freehand, lines arrows, shapes, colours & text that can create and alter bmp/jpg's - any recommendations?

-Brian

: > : the FWD label is going the wrong way. : > : : > : -- : > : bob z. : > : p.s. : > : : > : "people with less brain power than you are doing more difficult things : > : everyday"© : > : : > : : >

: >

: :

actually only 21 seconds if you look at the headers!

bob zee: Date: Wed, 22 Oct 2003 14:38:48 -0500 me: Date: Wed, 22 Oct 2003 15:39:09 -0400 LOL

i don't have any really good recommendations, but you might try this:

-- bob z.

"people with less brain power than you are doing more difficult things everyday"©

Nope, the forward label is correct, BUT it's a ZJ Grand Cherokee rear suspension, not an XJ front.

I win. What's the prize?

• * * Matt Macchiarolo
  formatting link
  formatting link
  formatting link

Hey now!

I think I already tagged it was the wrong one.... ;-)

Mike

Mike, maybe my reader didn't post your response, I only saw one from you...

Everyone except Bill thought the problem was the "FWD" arrow pointing the wrong way. That's incorrect. He came close when he guessed it was a diagram of a TJ rear axle, but if you look closely the upper lip of the frame indicates it's the frame member of a unit body vehicle, and the axlehousing looks like a Dana35, therefore it would be the rear axle, left side, from a ZJ Grand Cherokee.

What was the prize again?

:-)

• * * Matt Macchiarolo
  formatting link
  formatting link
  formatting link

I just said, 'what is right', I had it figured it wasn't what it was supposed to be... ;-)

Mike

Matt Macchiarolo wrote:

Hey Bob, you have a line on any Jeep related solid models?

Tom The Ox (Oxide) '86 CJ7, 258 I6, 4 spd, 3" Lift, 33x12.5 BFG's '96 XJ PMS '01 ZJ TS

Reply to: Group, or snipped-for-privacy@spleen.acd.net Remove my spleen to reply. (please be gentle) Home page:

I see two things. one the upper arm should have a a bushing in the axle and in the arm. that and its pointed the wrong way. that and mine has torx not hex bolts

Clymer's manual for Honda GL_1000 goldwings shows a diagram of carburettor jet locations where they reversed the locations of 2 jets, in the four carbs. The bikes run terrible that way, and get very bad mileage. It can be difficult to figure out, as it takes a real Honda manual to straighten it out. It has been dubbed "Clymers Disease" . Don't believe everything you read!

Interesting... when did they start using an offset pumpkin on the ZJ rear end? ;-) For your efforts, I will send you 1 lb. of genuine Canadian XJ door rust. This highly sought after collectable will come with a certificate of authenticity.

-Brian

Hey Bill, this is a front axle... no front leaf springs on the XJ... older FSJ's had them however.

-Brian

: > XJ Cherokee front suspension... as Chilton's sees it: : >

: > You will be graded on this test. : > -Brian