Where is the keyless module? Gr Cherokee 96

I want to hook up my remote starter to the keyless entry module to unlock/lock doors but cant find the wires or module. Can someone help with the location of the module or wires ??

thanks

Reply to
JS
Loading thread data ...

JS did pass the time by typing:

All I have is 93 schematics and I don't think they are valid past 95.

The 93 uses two wires, one to lock, one to unlock.

On mine the relay center is located under a panel in the glove box it was hard to get at so I intercepted the harness as it went to the drivers door. Those were 20 Gauge wires, Pink with Violet stripe for unlock Orange with Violet stripe for lock

You could check the wires coming from the door and look for the ones that get 12V when you hit lock/unlock.

... problem is that doesn't disarm the stock alarm system ...

To solve that I traced the entry keys disarm switch from the driver door (18 gauge violet with yellow stripe) and tied it to ground using a relay that kicks off when the unlock signal hits.

Drawback, this means that anytime someone hits the unlock button it disarms the stock alarm. Not a good thing. I didn't care because it was a Clifford alarm system with remote start that was going in.

If your remote starter has a disarm output (or ground closure) you could probably use that directly. Me, I like using those little bitty

12v relays.
Reply to
DougW

"DougW" a écrit dans le message de news: O_Mhf.42901$2k5.6799@dukeread09...

Thanks for your response Doug

Still no go. The manual does mention the orange/violet and pink/violet for lock/unock but I cant find them anywhere. I checked all wires on the drivers door plug with a probe and only two are giving pulses and they both pulse on lock or unlock... I think maybe its a data bus and the information goes thru the same wire. Maybe this is different from the other grand cherokee because its a limited edition.

Reply to
JS

JS did pass the time by typing:

might have to try the dealership and see if they have a maintenace book with schematics you can look at. That or contact the folks that made your remote starter and see if they have any better instructions. An other way might be to find a local alarm/sterio shop and see if they have information on your vehicle.

I think if your looking at the drivers door harness the colors are different. those colors match the wires running from the dash side of the connector.

Reply to
DougW

Reply to
philthy

Reply to
philthy

Reply to
L.W.( ßill ) Hughes III

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.