How easy to do as a home job? Do you need a press etc? Or, if i can get a hub cheap enough can it help me at all?
Nige
P38 Rear Wheel Bearing
Jun 22, 2006
2 Replies
Nige:
It's been my experience that the hubs are typically sealed units and there is no need for a press. Typical shop tools can replace these units. A torque wrench may be required when fitting hub nut.
Jack
There's no need to relace the whole hub anymore - the bearings are available seperately. Some sort of press/vice is going to be needed.
Richard
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required