Will my series IIa rims fit on an early discovery?
rim compatibility
May 01, 2006
3 Replies
Probably.
The stud pattern is the same but you will have to use nuts which are compatible with the Discovery. Early series nuts were 9/16" BSF which are not.
Other than that the only sure way is to try them. Be especially careful if the old rims are SDC (split) rims - the studs/nuts holding the two halves together might contact the calliper.
The offset is different (how different depends on whether LWB or SWB) but the stud pattern is the same on 2a/Disco 1. JD
but you'll have to hammer the centre's out to get them on the hubs. Some may say that's Not A Good Thing.
Richard
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required