swivels - ep-90 or grease?

On or around Fri, 17 Sep 2004 13:37:30 +0100, Mr.Nice. enlightened us thusly:

it was on mine. not easy to find under all the crud. and beware of the thing about it having a letter on the end, mine had a "B" which I misread as an "8" and therefore ordered the wrong CV joint for it, buggrit.

On or around 17 Sep 2004 13:37:44 GMT, Simon Barr enlightened us thusly:

if the axle casing is very rusty it could be rusted off, otherwise it's stamped on there. I forget which of front or back, though. might've been back, I know I had trouble finding it initially.

buggrit can't see an axle number so I'm putting ep-90 in.

Regards. Mark.(AKA, Mr.Nice.)

My axle isn't too rusty. I tried wire brushing the area where it's supposed to be but couldn't see a thing.

Manual reckons it should be on the front LHS on the upper bit of the axle tube, so did the parts man. I'll take a look round the back too.

On or around 20 Sep 2004 08:21:36 GMT, Simon Barr enlightened us thusly:

I've an idea mine was somewhere it "shouldn't" have been. certainly was there though, when I eventually found it.