what thread on 101 oil filter housing compressor feed?

Question

Does anybody have any idea what the thread on the 101 oil pressure switch is and what the thread on the end of the oil take off pipe for the compressor oil feed is?

(ive removed my compressor so dont need the oil feed)

I'd like to fit both an oil pressure warning switch and the sender for the gauge and it would be easier to put them in 2 holes rather than use a T piece.

I have put the sender for the gauge in the pressure switch hole and the pressure switch would be safer in the other hole since it is smaller and less likely to get knocked on something.

However - if i take the plug out of the feed hole for the compressor all my oil will come out (as it is right at the bottom) and i'd rather avoid this if i could.

Nige · Accepted Answer

Dunno, but I'm thinking of repainting Morph in a very trendy WW2 'ambush' type camo pattern, like thet did on some of the later Tigers & Panthers. The base colour is already there!!Like this -

EMB · Answer

Go for it.

Simon Isaacs · Answer

On Thu, 14 Dec 2006 19:58:36 -0000, "Nige" scribbled the following nonsense:you'll upset the rivet counters.... wrong type of cammo pattern!!!!

Nige · Answer

Well, they can kiss my hairy white arse then can't they!!!!!

JacobH · Answer

Nah, they'll never see it!

Lizzy Taylor · Answer

Is there a correct paint job for a prototype anyway?LizzyPS You're still waiting for SWMBO to pop then?

Lee_D · Answer

Lizzy Taylor  uttered summat worrerzfunny about:Yes, Bronze green. as in the piccys. D

steve Taylor · Answer

Hope you get away with it, I rather like that myself.Steve

Dougal · Answer

I stumbled across this should you wish to experiment electronically:

what thread on 101 oil filter housing compressor feed?

Join the Discussion

Didn't find your answer?