1999 Fiesta heated rear screen contact block

Up to '95 according to the manual, you remove the trim, then undo the two screws retaining the contact switch.

To remove the trim you had to undo seven plastic retaining screws, but I don't know if that applies to later models.

HTH

Andy Pandy To e-mail, address hopefully, self-explanatory !

They are about a tenner, they prise out on the one I did recently but that was a 96. The casing melts and gets stuck though, so some force is needed sometimes. Buy a new bit first and the attachment is obvious.

MrCheerful

The contact plate prises out but I believe the pins are fixed with screws !

Andy Pandy To e-mail, address hopefully, self-explanatory !

Andy Pandy To e-mail, address hopefully, self-explanatory !

Quite right, I didn't read the post carefully enough.

MrCheerful

Thanks for the info when I was younger I would have been straight in there prising with the screw driver but now I am older with deeper pockets I like to ponder things first thanks again.

I bought the pins and the block £19.00 & £12.00 each,the pins have two screws that need to be loosened and the whole lot can be removed,the block just prises out, five minute job.