Custom Manifold plate

I need to raise my upper inlet manifold/plenum chamber by about 5mm, Does anyone know of a place that can custom make me a plate. Thanks Andrew

1989 Cadillac Allante
Reply to
Andrew
Loading thread data ...

in what area?

Reply to
Mrcheerful

I'm in London, but can travel or post a gasket as a plan.

Reply to
Andrew

if it is just cut from a sheet then you could do it yourself, or wander round an industrial estate near you till you find someone suitable. you could go to somewhere like unicorn laser cutting in tyne and wear, they do that sort of a job, but I expect there is some local place that could do it, you could ask Burton engineering at ilford, they can probably do it or tell you someone that will.

Reply to
Mrcheerful

If you think you'll need to fettle it then water cutting doesn't leave the edge glass hard :=) Google or yell.co.uk for somewhere close.

Reply to
Duncan Wood

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.