Howdy,
If anyone has a 65/66 convertible with rear seatbelts installed, I am trying to find out exactly where to mount them. No holes that I can find in my 65, and I believe that the 66 had holes factory made in the floorpan, so could use them as a reference.
If you have them installed and could take a picture of the rear seat area showing the mounting points, I would appreciate it greatly!
Thanks ....
Michel.
You'll want to look for the VIN stickers on the various body panels. That will tell you if there has likely been a repaint or potentially body damage done to the car.
There should be stickers on the underside of the hood, inner portion of each front fender (viewed with the hood open, in the area where the hood seals), front nose cap (viewed with hood open), under side of each door (viewed with door open), and underside of trunk lid. It's been several years since I had a Mustang, so those are all the places I can think of off-hand.
You'll look for a sticker with the VIN on it, in each of these places. If you find that it has been either painted over or the sticker has something like "Ford DOT," then you may want to ask more questions about the car.
When repainting, most shops will just paint over the sticker. At best, they may mask it off. If the entire body panel has been replaced, the replacement panels have the "DOT" sticker.
Steve
72 Skylark Custom455MJT wrote:
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.