Wanted: 280ZX Turbo flywheel and clutch. Must be in NSW, Australia.
Cheers
No Spam Please
snipped-for-privacy@NOSPAM.hotmail.com
Remove the obvious spamtrap
Wanted: 280ZX Turbo flywheel and clutch. Must be in NSW, Australia.
Cheers
No Spam Please
snipped-for-privacy@NOSPAM.hotmail.com
Remove the obvious spamtrap
FWIW any 2+2 280z or 280ZX flywheel is the same thing. All use the 240mm disk.
That's good to know Steve, thanks. However we didn't get the 280Z's in Australia. We only had the 260Z's till the ZX came along. I don't think the 260Z 2+2 had the 240mm flywheel.
Cheers
No Spam Please
snipped-for-privacy@NOSPAM.hotmail.com
Remove the obvious spamtrap
Steve do you think it is possible to fill weld the groove in a 260Z flywheel and then have the face machined out to the 240mm to suit the turbo clutch??
Cheers
No Spam Please
snipped-for-privacy@NOSPAM.hotmail.com
Remove the obvious spamtrap
I'm pretty sure the pressure plate bolt pattern is different as well.
Yeah that would be right. A friend has suggested that a flywheel and clutch from a Nissan Patrol
4X4 with a L28 engine might do the trick. What do you think?Cheers
No Spam Please
snipped-for-privacy@NOSPAM.hotmail.com
Remove the obvious spamtrap
They never sold them here or at least haven't in a LONG time!
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.