Computer reset

Nov 07, 2009 8 Replies

I have a 406 diesel estate on a 52 plate which needs a computer reset could anyone tell how much this is likely to cost at a Pug agent



Thank you



Bryan


To be honest, I have used this group continuously since 2003 and have never seen anything concerning computer resets so I think it unlikely that you will get a meaningful response. The only possibility is Nigel who is, I believe, a Peugeot mechanic but I have not seen a post from him for some time. I think you will have to bite the bullet and approach an agent for a price. It would be very useful for any future poster with a similar problem if you would come back and add the outcome of your problem to this thread. Good luck.

Thank you Tinkerer I think you are right, I will ring the Pug agent tomorrow and report back once I have recovered from the shock.

Bryan

My fingers are crossed for you ;o)

It may also be worth looking for a Pug/Citroen specialist. They're often a lot (and I really mean a lot) cheaper.

On Thu, 12 Nov 2009 22:15:22 GMT, "malc" wrote

Have you any phone numbers for such specialists anywhere in UK? I personally have never run across one. (Portsmouth area southern UK, and none found in local yellow pages). A few numbers from you might be useful to everyone here!

Is Poole too far for you?

Steve

There is an independent in Romsey as well. There should be lots around, normally set up by disgruntled Pug trained technicians.

Bob

Belbins Garage Citroen & Peugeot Specialist

Unit 4 Belbins Business Park Cupernham Lane, Romsey, Hampshire SO51 7JF

p: 01794516999

On Fri, 13 Nov 2009 10:45:50 -0000, "shazzbat" wrote as :

Poole is fine if one is in need! I have to go miles and miles to get to a main agent anyway. I will start a new thread "UK Search for independent Pugeot/Citroen specialist mechanics" Maybe we can get some actual real useful information on these seemingly rare guys posted in the ng!

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required