(04 Cav) The replacement FWB hub assembly comes with an oil seal, to go on the inside of the knuckle. ISTM, you'd have to pull the knuckle to replace it. Am I just missing something? Do ppl do that?
Thanks
FWB hub assembly oil seal (Cavalier)
Jun 30, 2014
1 Replies
Usually not hard to do. If you pop the lower ball joint out to get room for the axle to retract enough to get to the hub bolts you just remove the hub, drive out the seal from the front and install the new one into the bore after you clean up the bore.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required