How to??
thanks
98 Intrepid, wiper arm removal?
May 18, 2004
3 Replies
First reply
If it is like my 95 Eagle.... 1. Lift up on the arm 2. Locate a small tab at the base of the arm (where is connects to the transmission assembly). Using a screwdriver, pull out on that tab. Shouldn't require that much force. Let arm back down and it should rest on that tab. 3.…
Read the full reply
If it is like my 95 Eagle....
- Lift up on the arm
- Locate a small tab at the base of the arm (where is connects to the transmission assembly). Using a screwdriver, pull out on that tab. Shouldn't require that much force. Let arm back down and it should rest on that tab.
- Pull arm off.
If yours isn't like this, dis-regaurd this information.
Hope this helps!
Straight from the FSM: You have to remove the plastic/rubber cap at the center of rotation (pry off carefull with something that won't scratch the metal). It conceals a nut that you of course loosen, and then wiggle the arm off of the shaft.
Bill Putney (to reply by e-mail, replace the last letter of the alphabet in my address with "x")
It is possble to change blade rubber without removing arm.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required