General Ford Forum

14521 Threads Posts
to

1983 Bronco catalytic converter

Hello, I have a 1983 Bronco (full size) on which a previous owner modified the exhaust. The PO removed the catalytic co...
2 comments posted 9yrs
posted by tom
2 comments posted 9yrs posted by tom

What should I do with my truck?

I have a 1988 F-150. It seems to run ok, but the CHECK ENGINE light is on. There is a commercial on tv that says "Once...
6 comments posted 9yrs
posted by bobconway
6 comments posted 9yrs posted by bobconway

Crankshaft fell out of my 2002 Taurus

I started my 2002 Ford Taurus and drove about 3 blocks, then my crankshaft fell out onto the road. The pistons were sti...
1 comments posted 9yrs
posted by jake
1 comments posted 9yrs posted by jake

2002 Taurus Duratec rear manifold replacemet.

Anyone here ever have the opportunity or priveledge to change the back bank exhaust manifold/integrated Cat Converter o...
0 comments posted 9yrs
posted by clare
0 comments posted 9yrs posted by clare

a little rant

Ok, so as you know, due to my belt squeaking, I decided to not only replace it but the tensioner and idler pulley too....
14 comments posted 9yrs
posted by ajstj
14 comments posted 9yrs posted by ajstj

How can I make a 2015 e250 Van ride smoother?

I have a 2015 e250 Van. Converted it for handicap use. It rides very rough/stiff. I threw a few hundred pounds in the b...
1 comments posted 9yrs
posted by JNelson
1 comments posted 9yrs posted by JNelson

American Experience: Tesla

No matter what you might think of his theories, he lead an interesting life. American Experience Episode: Tesla PREMIER...
5 comments posted 9yrs
posted by rander3128
5 comments posted 9yrs posted by rander3128

Troubleshooting Alternator / Voltage Reg

Alternator is not charging battery. Connections and cables are all good, no voltage drops. Battery holds a charge, chec...
22 comments posted 9yrs
posted by Snuffy-Hub-Cap
22 comments posted 9yrs posted by Snuffy-Hub-Cap

Alternator or regulator?

The charging circuit on the 97 Aerostar finally failed completely. The current had been cycling when running and headli...
3 comments posted 9yrs
posted by Snuffy-Hub-Cap
3 comments posted 9yrs posted by Snuffy-Hub-Cap

'96 Ranger 4.0

Just fixed 2 squeaks under the hood of the long-ranger. First I replaced the belt tensioner which had both bad bearing...
4 comments posted 9yrs
posted by clare
4 comments posted 9yrs posted by clare