4 cylnder 5 speed i had a new clutch .presure plate -throwout bearing put in 4 months ago/ did not change slave cylnder...any how now every 3 weeks i must bleed the clutch ..seems there is allways a air bubble at the slave ...there is no fluid leak at all...it just some how gets a air bubble in the line at the slave cylnder ...i bleed it and it works fine till 3 or 4 weeks go by then when it starts hitting teeth i blead it again ...theres only
1 pass of air each time it needs blead......any ideas on this
1994 ranger ???
Mar 30, 2006
Last reply: 20 years ago
3 Replies
yeah. how did they change the throw out bearing with out replacing the slave?
Whitelightning
On Fri, 31 Mar 2006 04:20:04 +0000, Whitelightning rearranged some electrons to form:
Put the old one back on, maybe?
the throwout spring and bearing snap in place.....no lines have to be loose to change....
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required