broken passenger window

If you have comprenhisve insurance, I'd take it to a glass shop. If you feel the need to do it yourself here are the steps -

Removal

1) Remove front door trim panel and front door trim shield.

2) Raise front door window glass (21410) to full up position.

3) Remove rear glass run retainer from front door (20124).

4) Lower front door window glass to gain access to front door window channel bracket and glass retention rivets. NOTE: Use care when drilling not to damage glass bracket and spacer/retainers.

5) Remove center pin from the glass retention rivets using a drift punch. Then, use a 6.35mm (1/4-inch) diameter drill and drill out each rivet.

6) Remove the front door window glass through the door window opening.

Installation

1) Install spacer and retainer into glass retention holes.

2) Install front door window glass into front door through the door window opening.

3) Position the front door window glass to the front door window channel bracket and align with the retaining holes.

4) Install retaining rivets.

5) Raise front door window glass to full up position.

6) Install the rear glass run retainer.

7) Cycle front door window glass up and down to check operation.

8) Install front door trim shield and front door trim panel.

Before you start, check with oyur insurance!

Ed

Susan wrote: