Hi,
Is a 1-ton arbor press enough to press-fit the bearing and retainer ring on a axle shaft without too much trouble?
If not, what would be enough? A 2-ton arbor? A 12-ton hydraulic?
I want to avoid using the bfh.
/herb
Hi,
Is a 1-ton arbor press enough to press-fit the bearing and retainer ring on a axle shaft without too much trouble?
If not, what would be enough? A 2-ton arbor? A 12-ton hydraulic?
I want to avoid using the bfh.
/herb
That's a pretty good looking trick for removing the old bearing/retainer. Now to find a spare d44 axle shaft that will fit... /herb
In article , L.W.(ßill) Hughes III wrote: # #
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.