Disco I, 1995 vintage. The self-park on the wiper has gone flaky, which also affects the intermittent wipe... I've not looked yet but I'd bet on the parking switch on the wiper motor, or possibly a wiring fault.
If it's the former, can the switch be replaced by itself or is it new motor time?
and while youre there Richard, do you keep series halfshafts in stock? (short rear one 10 spline)
In article , Austin Shackles writes
For the Defender, isn't there a diode in there somewhere that dies? I've got to molish Marge's wipers soon (same problem), but I don't know how similar they are to a disco's setup.
The last one I dismantled was GM, but it was just bendy copper strip and relatively easily bodged ISTR.
Regards,
Simonm.
As far as I can tell, it's new motor time - BUT both the books and MicroCat are very vague on this - I'll have an investigate.
Richard
591378 Rear Short Half Shaft 88 pre 80 £14.10 inc VAT in stock 591379 Rear Long Half Shaft 88 pre 80 £15.24 inc VAT due in Monday.
Richard
When are you about on saturday? I now have a shopping list ;)
I was going to try and visit you today but ended up having an important business meeting in the pub instead!
8.00am to 2.00pm (but usualy around till about 5 - ring first after 2!)
We're open 8.00am - 2.00pm (with a break from 11.15 to 12.15) Sundays for just that reason...... ;-)
Richard
I shall be over there shortly then!
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.