1. Home
  2. Land Rover 4WD vehicles
  3. Range rover chassis

Range rover chassis

Lo Again

This range rover is causing me problems :( but at least it running sweet now, thanks for the info on the oil pump) I need to fit new body-chassis rubbers, its had new sills fitted (Welder was a complete *ickhead, but thats another story) but i need to lift the body a bit to get the rubbers in.

I THINK i have found all the body-chassis mounting bolts, but still cant separate the body from the chassis.

2 at the front by the radiator, 2 on the bulkhead, 2 on the rear cross member, and 4 on the outriggers, and 2 smaller ones roughly in the middle on the inner chassis.. are there any more ?

its a 1980 2 door bobtailed if that makes any difference.

Regards Bobtailed Bob

Reply to
Bobtailed Bob
Loading thread data ...

10 sounds right - all the same size. Positions as you describe.

The seat belt (and front seat in the case of a two door) mountings also effectively join the body and chassis. I think that there are four of them: you've got another two to find!

Reply to
Dougal

Appologies for the dealy in replying, i can only 'play' with the rr on Saturdays :( Many thanks for the tip Dougal

Couldnt find the 2 missing seatbelt bolts (I have bucket seats and harnesses installed and they are mounted to the seat frame) Having said that that i DID manage to get the rubbers fitted eventually.

Reply to
Bobtailed Bob

Hmmm first reply didnt appear ??

Many thanks for the reply Dougal

Couldnt find the 'missing' 2 mountings my rr has bucket seats and harnesse and the harness is mounted on to the seat chassis A bit of brute force and ignorance later and i managed to get enough room to fit the rubbers.

Reply to
Bobtailed Bob

Reply to
Dougal

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.