Can anyone offer some advise please? I am trying to replace the freeze plugs in my cooling system on the block and can't figure out how to remove the old ones to install the new. Sure would appreciate any advise you guys can give me.....Shar
1983 Mustang Conv
Sep 15, 2003
5 Replies
Sharon opined in news:7Sh9b.54722$cj1.42288@fed1read06:
I think the Haynes and Chilton books tell you how.
Drill hole in center, rachet in a lag screw, Pull it out using puller center bar OR use a punch or bolt around edges to punch the thing loose. Use vise grips to pull thing out
Its easy! Just knock in one side of the old freeze plug, and use a pair of pliers or vise grips to pull it out! Don't worry...its not going to fall inside where you can't get it out.
Are the originals leaking?
use a punch to punch the thing loose then use vise grips to pull it out...just be sure to use the better brass plugs when you go back and keep your antifreeze level correct and you wont have this problem again.
Randy
Randy, Thank you so much for replying I can't believe what a night mare this turned out to be. I will take your advise and let you know the results. Thanks again! Shar
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required