i have taken off the imobiliser on the back of the bosh pump and fitted a solenoid with 1 wire switched live, but there is no fuel getting to the injectors, thre is fuel going in and fuel going out of the return pipe , i have turned the engine over by cranking with n0 1 injector loose. this the same problem before i took off the imobiliser....any help apreciated...pep
peugeot 106 diesel no fuel
Dec 09, 2003
3 Replies
Hello,
cranking with n0 1 injector loose. this the same problem before i took off the imobiliser....any help
What about the stop solenoid ? Is there 12V on it ?
Regards, G.T snipped-for-privacy@worldonline.fr
205 Diesel & turbo-Diesel :
formatting link
yes there is 12v at the solenoid, and its a new onecould it be the pump...
So I assume it works if it's new... My best advice would be to see if gas oil comes out if you unbolt one of the "solid" pipes, say one of these on injector's side. When you turn over, the fuel should squirt. Best to be two, one commanding starter, the other one looking the engine. Well, here's what I'd do (keep in mind I'm not a mechanic) : 1/ check there are 12V on the glow plugs (no need to check all four, one is enough) when ignition on, warning : only 10 sec to measure ; 2/ check solenoid voltage, 12V ignition on ; 3/ check fuel leaking after you unbolt one pipe as I said above ; 4/ If you come to this point, well, it could be the pump.
Regards, G.T snipped-for-privacy@worldonline.fr
205 Diesel & turbo-Diesel :
formatting link
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required