Automotive Technologies

  1. Home
  2. Automotive Technologies
15186 Threads Posts
to

Worth reading in Automotive Technologies

89 vs. 92 trans compatibilty

Hi all, just a quick question: I have an been offered a parts car for free (89 Taurus 3.8L), the engine and tranny are...
3 comments posted 20yrs
posted by demeyz5
3 comments posted 20yrs posted by demeyz5

1990 FORD ECONOLINE 150 VAN Questions!

Thanks in advance for taking the time to read my mammoth post. I bought a Ford 1990 Van about 6 months ago. It only had...
1 comments posted 20yrs
posted by ziabox
1 comments posted 20yrs posted by ziabox

Older GTP - How much low end power to expect?

I have a 95 Grand Prix GTP, but I have only owned it for about a year and I'm not sure if it's performing as well as it...
3 comments posted 20yrs
posted by suekaaron
3 comments posted 20yrs posted by suekaaron

abs warning light stays on

on a '93 t-c chrysler minivan after just having a recall issue on the abs brakes repaired, it comes on and stays on mayb...
0 comments posted 20yrs
posted by fiveiron
0 comments posted 20yrs posted by fiveiron

Gasoline with Ethanol

The gas pumps where I normally trade are the same old ho - hum type, summer, winter, makes no difference, never a notic...
19 comments posted 20yrs
posted by fiveiron
19 comments posted 20yrs posted by fiveiron

Garage sale find

So, i find this little Dodge Ram 50 2. 0 truck at a sale for 250 bucks. It ran fine when i test drove it, saw no appear...
5 comments posted 20yrs
posted by motheroftwoprinces
5 comments posted 20yrs posted by motheroftwoprinces

Shop Press for Bushings: Adapters?

I am considering purchase of the following 12-ton, "Central Hydraulics" A-frame, shop press for removing old control ar...
6 comments posted 20yrs
posted by honda.lioness
6 comments posted 20yrs posted by honda.lioness

Altima hesistation off idle, revisited again!

Ok, so I'm still trying to figure out my hesitation off idle in my 1999 Altima. I've checked for vacuum leaks and I'm r...
23 comments posted 20yrs
posted by jmsn
23 comments posted 20yrs posted by jmsn

Beretta toe problem solved

Amazing what happens when Canadian Tire calibrates their equipment. The rear toe magically went from -3/8" to +1/8" on...
2 comments posted 20yrs
posted by rollingviolation
2 comments posted 20yrs posted by rollingviolation

Consequences of a bad engine mount?

My 05 Maxima SE (25,000 miles) , when hot, sometimes sounds like a very rough diesel at idle and row RPMs. A dealership...
2 comments posted 20yrs
posted by 223remi
2 comments posted 20yrs posted by 223remi

head mounted LED torch/ flashlight

Hi, I wish to buy a LED torch/ flashlight that is mounted on the head so as to leave both hands free. Could anyone recom...
27 comments posted 20yrs
posted by blue.star77
27 comments posted 20yrs posted by blue.star77

filipinas for marriage

http://www.dating-filipina.com The best women in asia for marriage, devoted Catholic ladies, as long as you catch them...
1 comments posted 20yrs
posted by datingfilipina
1 comments posted 20yrs posted by datingfilipina

Old Sear & Roebeck 1kw Generator

Anyone out there have a wiring diagram for these old units? I can "peg" out the wiring with an ohmeter and figure out (...
1 comments posted 20yrs
posted by long.shanks
1 comments posted 20yrs posted by long.shanks

Specification mentioning HP and BHP

Hi, I have seen several advertisements of the lightweight two wheelers saying its engine has Horsepower of 1.5 HP. Some...
1 comments posted 20yrs
posted by jainbi
1 comments posted 20yrs posted by jainbi