I have a Toyota Camry 2001 4 cyl 64000 miles. Does this car behaves only if I service it at the dealer? I flushed and replaced the steering fluid at a station specialized on oil service. They show me that the fluid is dirty and needs to be changed after 60000 miles. I asked them if the replacement fluid is the right one for Toyota, they said yes. Two days after the change when steering, I hear that high pitch noise (it seems that noise comes from under the hood not from the steering column) and the steering wheel moves very hard. This happens when steering on both right or left side, not every time (4-6 times in 10 days) and I think when it is cold outside. The fluid it is a the right level. What might be wrong? Thank you.
Power steering noise after flushing/changing the steering fluid-Camry 2001
Dec 26, 2005
8 Replies
loose belt - or, perhaps they spilled a bit of power steering fluid on the belt surface when flushing - that could also cause it to slip, make the noise, and not drive the pump properly which would result in additional steering effort. Suggest replacing the belt with genuine Toyota part and see if you can find someone to actually get the tension correct. May not be as simple as it sounds. I replaced my own a while back when I did the timing belt, and checking about a week later, the belt was not sufficiently tensioned according to the factory service manual. Can't remember if I had to tighten it again after that. Should be easy enough to install a new belt such that it doesn't slip, although if there's residual spilled fluid on the pulley that should also be cleaned to avoid contaminating the new belt, but actually using a tension gauge to meet factory specs would be the next step. I suspect most mechanics do not do this, but the tension in pounds is given and also listed as a periodic maintenance item, so I set it to factory specs. By the way, the alternator belt, which has to come off to reach the P.S. belt, seems like it has to be really tight according to my Burroughs belt tension gauge to reach the 90 or so pounds listed in the manual, but if it is looser, and the car downshifts, revs up to higher speed, you'll see quite a bit of "fluttering" in the belt, so I assume Toyota has good reason for specifying belt tension in pounds rather than "push it with your thumb and see if it moves apx. 1/2" "
Many older Toyotas use Transmission Fluid in Power Steering not power steering fluid, But it should not make a noise, it could be debris loosened, a loose or oily belt, take it back, read your manual, trans fluid is Red. The cap on the resivour, it should state what is required by Toy.
No telling what they put in there at those places..if you dont see any fluid dripped on your belt, they may have used the wrong fluid. I buy a quart of toyota ATF fluid at the dealer for a couple bucks and do this myself with a large syringe. Go back there and find out what they did. I would go to Toyota and have it done right and get them to pay for it.
Rob, do you replace the resvoir fluid only?
Looking to do mine ('96 4cyl manual)
Jason
I use a turkey baister at your local grocers.
Similar to the one that your mother used to enable YOUR conception?
>Probably the same one.
I tried that, but first, the grocer objected to me driving my car in his store, and second, he wanted me to actually pay for the turkey baster.
Merritt
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required